Damage Analysis Of SKF Bearings

To check the damage of SKF bearings, it can be found that in most cases, it may cause them. Generally speaking, only one-third of the damage caused by fatigue damage of SKF bearings comes from when poor lubrication occurs, and the other one-third From pollutants into the bearing or improper installation and treatment. However, these types of damage are irrelevant. Industrial bearings are precision parts, so it takes a long time to be cautious. Even with high-performance bearings, if improperly used, the expected performance effects cannot be achieved, and the bearings are easily damaged.

Therefore, the use of SKF bearings should pay attention to the following points:

First, keep the SKF bearing and its surrounding environment clean. Even the tiny invisible dust entering the bearing will increase the wear, vibration and noise of the bearing.

Second, use and install carefully, make powerful punching, and not allow direct hitting of the bearing with a hammer, which does not allow the pressure to pass through the meridian.

Third, appropriate and accurate installation tools to use special tools, try to avoid the use of cloth and short fibers.

Fourth, to prevent the bearing from corroding, directly select the bearing by hand, thoroughly wash the sweat of the hand, and then use high-quality mineral oil to pay special attention to rust prevention during the rainy season and summer. However, under certain special operating conditions, bearings can achieve a longer life than traditional calculations, especially under light load conditions. These special operating conditions are when the rolling surface (track and rolling parts) is an effective lubricating film to separate and limit contaminants that can cause surface damage.